!-- Google Tag Manager --> E76 Elite Series 7.6 Cu Ft Vacuum Oven | Cannabis Extraction Equipment - AiVacOvens

E76 Elite Series 7.6 Cu Ft Vacuum Oven

The all new E76 is our largest Elite-series oven (second largest overall), and is the perfect solution for large scale operations with high production volumes. It comes equipped with 7 removable aluminum shelves, a massive 7.6 cubic foot chamber capacity, and our newly redesigned jacketed heating system.

5-Side Chamber Jacket Heating

The heating jacket covers the left, right, top, bottom, and backside of the oven chamber. This provides perfect temperature uniformity, temperature accuracy, and rapid heating rates.

Accuracy

In addition to our in-shelf heating, the low proportional gain temperature controller keeps your oven’s temperature within +/- 1°C accuracy while in use.

 

Optimal Vacuum Levels

Our ovens greatly reduce drying time of your extracts by maintaining a deep, consistent vacuum level within the chamber – making them the best choice for curing and converting oil extractions.

Increased Productivity, Quality, and Consistency

Our ovens produce deep vacuum levels that allow them to operate at the optimal temperature for allowing the purging process to occur rapidly. The result is an increase in the consistent output of superior quality extracts with a minimal processing time.

DimensionsOven chamber = 23.6″W x 23.9″D x 23.6″H / Unit = 34″W x 32″D x 45″H
InteriorPolished type 304 stainless steel
Safety FeaturesBuilt-in safety switch, circuit breaker, overheat protection, power failure auto reset, and time up buzzer
Shelves7 removable aluminum shelves
Temp ControlMicrocomputer PID control for heater output
Quality ControlAll vacuum ovens undergo a 24hr vacuum leak test twice and are 100% quality controlled at either our New Jersey or Nevada facility before shipment.

 

All vacuum ovens are intended for lawful use only.

Attention – Before Initial Use: Run oven at 400°F without vacuum for a total of 15 minutes to burn off any residue that may have been introduced during the manufacturing process.